Avaya BCM50 User Manual download pdf (Page 6)

IP Routing

6 NN40011-044 Issue 1.2 BCM50 Rls 6.0

uses the routing table information to determine the next host for the packet,

until the required destination is reached.

BCM50 Integrated Router allows RIP to be enabled/disabled, and also the

direction set against RIP information updates, i.e. RIP information can be sent

to other routers, accepted from other routers, both sent and received, or

turned off.

BCM50 Integrated Router supports two versions of RIP:

 RIP 1 – universally supported, probably adequate for most networks

 RIP 2 – offers more information than RIP 1, but you must check that

other routers are compatible with this protocol

Enabling RIP on Network Interfaces

The BCM50 Integrated Router supports RIP on the following interfaces:

 LAN-side

 LAN IP Alias

 WAN-side

Therefore, the BCM50 Integrated Router can send (and/or receive) RIP

information to other routers connected to the LAN (either on the same network

range, or network ranges specified by IP Alias) and also to routers connected

via its WAN port.

LAN-to-LAN Routing

BCM50 Integrated Router offers the IP Alias feature to provide up to 3

different network ranges via the same physical interface (essentially LAN

ports). The BCM50 Integrated Router can be used to automatically route data

traffic between any network range.

Required Information

Before configuring IP Routing, the following information is required:

 Which interfaces (LAN or WAN) are other routers likely to be connected

 Which method of routing should be used: Static Routes or RIP

 If static, what are the IP Addresses of other immediately connected

routers

 If using RIP, which version: RIP 1 or RIP 2

 If using RIP, are there any constraints as to the direction of RIP

information transmissions

1 2 3 4 5 6 7 8 9 10 11 ... 21 22

No comments

Avaya BCM50 User Manual Page 6