Avaya BCM MSC FRU Replacement Process User Manual download pdf (Page 10)

10 MSC FRU replacement process

NN40010-315 Media Services Card replacement

7 Type 8 (Restart the system), and then press <Enter>.

8 At the restart [A, R] prompt, type R, and then press <Enter>.

The system indicates that it is shutting down.

9 After the system shuts down (about 30 seconds), remove the BCM AC power connector from the AC outlet.

10 Remove the base function tray, as described in “B. Removing the base function tray” on page 5, and place the

tray on static-safe surface.

Next Step: You are ready to install the new MSC.

E. Installing the new MSC

1 Attach one end of the grounding strap to your wrist and the other end to a grounded metal surface.

2 Remove the MSC from the container and the static-safe bag.

3 Put the new MSC on a static-free surface.

4 Install the PECs onto the new MSC (Figure 5).

a Line up the card between the rails of the slot. Ensure the card label is faces up.

b Carefully slide the PEC into the slot until it is firmly seated.

c Repeat steps a and b for each PEC.

Figure 5 Insert the processor expansion card

5 Carefully hold the MSC by the edges, and position the MSC in the correct PCI riser card connector (lowest

connector, closest to the main system board) on the inside of the basic function tray.

6 Push the card firmly and fully into the PCI riser card connector.

Warning: Always wear a grounded wrist strap while you handle components.

Note: BCM200 MSCs support one or two PEC IIIs. BCM400 MSCs

supports two or four PEC IIIs or four PEC Is. Ensure that you replace

them into the same slots from which you remove them.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

No comments

Avaya BCM MSC FRU Replacement Process User Manual Page 10