Avaya Quick2Config User Manual download pdf (Page 26)

26 Chapter 1 Configuring switches

311208-A Rev 00

Configuring Ethernet ports

You can use Quick2Config to enable or disable switch and MDA ports, and to set

the port speed for an Ethernet port.

To set basic Ethernet port properties:

In the navigation pane, open the switch or Ethernet MDA and select a port. To

assign the same properties to a group of ports on the same switch, select

multiple ports in the navigation pane.

The port Basic tab opens in the context-sensitive pane (Figure 3).

Figure 3 Basic port properties

The Operational Status field indicates the current link state of the port, as

follows:

• Up indicates that the port is connected and operational.

• Down indicates that the port is not connected or is not operational.

The field is blank when you are working offline to create a new configuration.

From the Administration Status list, choose Enabled or Disabled to force the

link up or down.

From the Port speed list, choose the Ethernet line speed and duplex mode

combinations for the selected port; or, choose Autonegotiate to configure the

port to match the best service provided by the connected station, up to

100 Mb/s Full Duplex.

Valid options depend on the MDA hardware. Fiber optic links do not use

autonegotiation.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 95 96

No comments

Avaya Quick2Config User Manual Page 26