Avaya BayRS Version 14.10 Notice download pdf (Page 31)

Release Notes for BayRS Version 14.10 for the Passport 2430 and Passport 5430

308663-14.10 Rev 01

Deleting ATM from a Router if Signaling Is Enabled

Do not delete ATM from a Passport 5430 if you enabled signaling on an ATM

circuit. If you try to delete ATM in this situation, Site Manager, the BCC, or the

Technician Interface restarts after a few minutes.

Signal Ports Settings on a Switch and Router Conflict

If you are using a switch with signal ports set to V3.1, be sure to set the signaling

setting on the router to V3.1. If you accept the default setting of V3.0 for the

router, the router faults repeatedly until you change the setting to V3.1.

Creating FTP from the BCC

From the BCC, if you create FTP on the router, then delete it and recreate it, the

BCC faults. In this case, you must restart the BCC and create FTP on the router

again.

Using DVMRP with Interfaces with More than One IP Address

You cannot use the BayRS Version 14.10 implementation of Distance Vector

Multicast Routing Protocol (DVMRP) with circuits with multinetted interfaces

(that is, interfaces with more than one IP address).

Deleting a Hybrid Mode Permanent Virtual Circuit (PVC)

If you configure source route bridging on a router, do not delete hybrid mode

PVCs. If you do, all slots restart.

Using DLSw/APPN Boundary Port with AS400s and Other Adjacent

Link Stations

Do not configure any explicit APPN adjacent link stations on the DLSw/APPN

boundary (VCCT) port, unless you are certain that the adjacent link station (for

example, an AS400) will not attempt to connect to the APPN node. Otherwise, the

DLSw/APPN boundary (VCCT) function fails to operate correctly and the router

might restart.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 41 42

No comments

Avaya BayRS Version 14.10 Notice Page 31