Avaya Configuring BayStack Remote Access User Manual download pdf (Page 100)

Configuring BayStack Remote Access

B-4

308614-14.00 Rev 00

Router Not Sending BootP Responses

If a router between the BayStack router and the BootP server is receiving BootP

requests but is failing to send BootP responses, do the following:

Use Site Manager to ensure that the BootP relay agent forwarding table

associated with the router shows an IP address that is configured on the

IP router.

Ensure that the input IP address is correct. If the Hops count is lower

than the router’s position in the path, increase the Hops count.

For instructions, see “Creating the BootP Client Interface Table” on

page 3-13.

Use the Configuration Manager to ensure that BootP and IP are enabled

on the incoming and outgoing interfaces.

Ensure that the link modules and drivers are enabled.

For instructions, see Configuring and Managing Routers with Site Manager.

BootP Server Not Sending BootP Responses

If the BootP server is receiving BootP requests but is failing to respond to them,

do the following:

Follow the instructions in “Displaying the BootP Server IP Routes” on

page B-15

Follow the instructions in “Debugging the BootP Server” on page B-12.

Ensure that the

/etc/inetd.conf

file contains no more than one

bootps

entry.

If there is more than one entry, comment out the invalid entry. The valid entry

is as follows:

bootps dgram udp wait root /etc/bootpd bootpd

Ensure that the

tftp dgram

entry in the

/etc/inetd.conf

file is correct for

your system.

For instructions, see “Setting Up a TFTP Server” on page 2-9.

See “Verifying the BootP Server Setup” on page B-14.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 139 140

No comments

Avaya Configuring BayStack Remote Access User Manual Page 100