Avaya Configuring BayStack Remote Access User Manual download pdf (Page 104)

Configuring BayStack Remote Access

B-10

117341-B Rev. 00

• If the BootP server is not receiving requests, ensure that the upstream router is

receiving and forwarding them. If the upstream router is receiving, verify that

each router interface between the upstream router and the BootP server is

receiving and forwarding the requests.

If the BootP server is receiving requests but is failing to respond, see

“Router Fails to Netboot” on page B-3

Resolving Connectivity Problems

This section describes how to:

• Display the BayStack router’s netboot configuration

• Debug the BootP server

• Verify the BootP server’s setup

• Display the BootP server’s IP routes

• Display the number of BootP packets forwarded and dropped

Displaying Parameter Settings

Display the BayStack router’s netboot parameter settings to determine the

following:

• Whether the BayStack router is set to boot using a local boot image or a

remote boot image

• Whether the BayStack router is set to configure using a local configuration

file or a remote configuration file

• The configuration of the synchronous, Ethernet, and token ring (ARN only)

connectors

Enter the following Technician Interface command to display the BayStack

router’s startup options:

getcfg

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 137 138

No comments

Avaya Configuring BayStack Remote Access User Manual Page 104