Avaya Configuring Data Encryption Services User Manual download pdf (Page 30)

Configuring Data Encryption Services

2-4

308618-14.00 Rev 00

Log on as superuser.

% su

Enter the superuser password.

password

Move to the root file system.

$ cd /

Make a mount point directory.

$ mkdir

<directory_name>

Mount the floppy disk.

$ mount -t pcfs /dev/fd0

<directory_name>

Using Encryption with Dial Services

You can configure WEP to work with dial-on-demand, dial backup, and

bandwidth-on-demand services. Using WEP for these three dial services enables

you to protect sensitive traffic across switched circuits.

Configure encryption for a PPP or frame relay switched circuit as you would for a

leased circuit.

Encryption with Dial Backup

If you configure encryption to work with dial backup service, encrypted data

travels over the backup circuit if the primary line fails. You do not have to

configure WEP over the backup circuit, because the backup circuit takes the

configuration of the primary circuit. Encryption works with any PPP or frame

relay primary and backup circuit combination.

If PPP is the protocol for the backup circuit, ensure that the parameter RFC1661

Compliance (Site Manager) or

mru-compliance (BCC) is set to the default,

Enable, for encryption to work successfully.

To configure RFC 1661 compliance with Site Manager, see Configuring PPP

Services. To configure RFC 1661 compliance with the BCC, see Configuring Dial

Services.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 69 70

No comments

Avaya Configuring Data Encryption Services User Manual Page 30