Avaya BCM 4.0 Networking Configuration Guide download pdf (Page 333)

100

101

333

BCM 4.0 Networking Configuration Guide

Chapter 32

Public networking: Tandem calls from private node

If your system is connected by a private network to another system that does not have PSTN line

access, or which is not located within the local dialing range, you can set up a routing plan that

allows the users of the private network to dial into your system, and through your system to the

PSTN network. This type of call feature is referred to as tandem dialing. Refer to “Programming

for tandem dialing” on page 333.

The reverse is also true. You can set up routing so that calls from the PSTN can be passed through

your system and over the private network to the remote node. Also refer to “Private networking:

PRI and VoIP tandem networks” on page 363.

Figure 113 Tandem dialing through a BCM to or from a private network

Programming for tandem dialing

Since incoming lines terminate within the system, you need to set up routing to pass the calls along

to the required destination.

Lines:

• Set up private network lines as auto answer (if applicable).

• Put private and public lines into separate line pools.

• Assign lines to configured Remote Access Packages.

1 ... 332 333 334 ... 758

Comments to this Manuals

No comments

Avaya BCM 4.0 Networking Configuration Guide Page 333

Comments to this Manuals

Related products and manuals for Networking Avaya BCM 4.0 Networking