Avaya Business Communications Manager 50 Installation Manual download pdf (Page 229)

Appendix G BRIM wiring chart 229

Installation and Maintenance Guide

Appendix G

BRIM wiring chart

The digital BRI ISDN lines connects to the BRIM through the RJ-45 jacks on the front of the

media bay module (MBM). See the figure BRIM RJ-45 ports on page 229. You can connect up to

four BRI ISDN lines to the BRIM.

The figure BRIM RJ-45 ports on page 229, the table BRIM RJ-45 port wiring on page 229, and the

table BRIM line numbering on page 230 apply to S-Loop and T-Loop connections. S-Loops

connect S-Loop devices such as video phones, terminal adapters, and Grp 3 Fax machines. The

T-Loops connect to the CO/PSTN.

Figure 92 BRIM RJ-45 ports

The table BRIM RJ-45 port wiring on page 229 and the table BRIM line numbering on page 230

list the wiring details for the RJ-45 ports.

Warning: For a U-loop connection, you must connect the BRIM only to an NT1 supplied

by the service provider. The NT1 must provide a Telecommunication Network Voltage

(TNV) to Safety Extra Low Voltage (SELV) barrier.

Table 40 BRIM RJ-45 port wiring

Pin Signal Signal on system side

1 No connection No connection

2 No connection No connection

3 + Receive (+Rx) +Tx

4 + Transmit (+Tx) +Rx

5 – Transmit (-Tx) – Rx

6 – Receive (-Rx) – Tx

7 No connection No connection

8 No connection No connection

1 2 3 4 5 6 7 8

RJ-45 pin out

RJ-45 jacks

BRIM

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 300 301

No comments

Avaya Business Communications Manager 50 Installation Manual Page 229