Avaya Configuring IP Multicasting Services User Manual Page 29

  • Download
  • Add to my manuals
  • Print
  • Page
    / 103
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 28
Starting IP Multicasting Services
114064 Rev. A 2-3
Starting ST2
Before you can select a protocol to run on the router, you must configure a circuit
that the protocol can use as interface to an attached network. For information and
instructions, see Configuring Line Services.
When you have successfully configured the circuit, the Select Protocols window
opens.
1. Select IP and ST2 from the Select Protocols window and click on OK.
The IP configuration window opens.
2. Supply the following information:
An IP address for this interface. There is no default for the IP address.
You must supply an address or enter 0.0.0.0 to indicate that this is an
unnumbered interface. (For information about unnumbered interfaces, see
Configuring IP Services.)
A subnet mask. When you specify an address, IP automatically calculates
an appropriate subnet mask, depending on the class of network. You can
use Site Manager to override the default mask.
A transmit broadcast address. By default, IP uses a broadcast address that
consists of all ones. You can use Site Manager to override the default.
An associated IP address. If you are configuring an unnumbered IP
interface, use Site Manager to supply an associated IP address.
3. Click on OK.
Site Manager: IP Address parameter: page A-17
Site Manager: Subnet Mask parameter: page A-17
Site Manager: Transmit Bcast Addr parameter: page A-18
Site Manager: UnNumbered Assoc Address parameter: page A-18
Page view 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 102 103

Comments to this Manuals

No comments