Customizing ST2 Services
114064 Rev. A 5-13
Configuring the Tunnel Capability
By default, ST2 does not have tunneling capability. If your network requires the
use of tunnels to establish a neighbor-to-neighbor connection, you can use Site
Manager to configure the feature.
If you enable the tunnel capability on the router, you can use Site Manager to
disable and re-enable the feature.
Configuring an ST2 Interface
The following sections describe ST2 features that you can configure on an ST2
interface.
Enabling and Disabling ST2
By default, the router enables ST2 when you add an ST2 interface to the circuit.
You can use Site Manager to disable and re-enable ST2 on the interface.
Specifying an IP Address
You can use Site Manager to specify the IP address of this ST2 interface.
Site Manager: Tunnelling Capability parameter: page A-19
Site Manager: Tunneling Enable parameter: page A-19
Site Manager: Enable parameter: page A-20
Site Manager: IP Address parameter: page A-20
Comments to this Manuals