Avaya Configuring XNS Services User Manual download pdf (Page 61)

Editing XNS Parameters

303548-A Rev 00

4-25

Parameter: Target Network (hex)

Default: None

Options: Any valid network address in hexadecimal notation

Function: Specifies the address of the network to which you want to configure the

static route.

Instructions: Enter a network address of up to 8 hexadecimal characters.

MIB Object ID: 1.3.6.1.4.1.18.3.5.10.6.1.3

Parameter: Next Hop Network (hex)

Default: None

Options: Any valid network address in hexadecimal notation

Function: Specifies the network address of the next hop.

Instructions: Enter a network address of up to 8 hexadecimal characters.

MIB Object ID: 1.3.6.1.4.1.18.3.5.10.6.1.5

Editing a Static Route

You can edit the configurable parameters of a static route that you specified earlier

in the node configuration. The Configuration Manager does not allow you to

reconfigure the Target Network and Next Hop Network parameters for a static

route. If you want to change these parameters, you must delete the static route and

add a new route with the proper information. However, you can reconfigure all

other parameters associated with a static route.

To edit the configurable parameters associated with an existing static route, begin

at the Configuration Manager window (Figure 4-1)

and select Protocols > XNS >

Static Routes. The XNS Static Routes window appears (refer to Figure 4-7). From

this window:

Select the static route you want to edit. Click on the appropriate entry in

the list of static routes.

Click on any parameter value you want to change; enter a new value.

Click on Apply to save your changes.

Click on Done to exit the XNS Static Routes window.

1 ... 60 61 62 ... 72

No comments

Avaya Configuring XNS Services User Manual Page 61