Avaya 7-11.xx User Manual Page 66

  • Download
  • Add to my manuals
  • Print
  • Page
    / 110
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 65
Upgrading Routers from Version 7-11.xx to Version 12.00
4-16 117404-A Rev. A
7. Verify the PROM upgrade by entering the following command:
prom -v
<volume_no.> <Diag_PROM_source_file>
<slot_ID>
For example, for a boot PROM, enter:
prom -v
<volume_no.>
: [freboot.exe | asnboot.exe | anboot.exe |
arnboot.exe]
<slot_ID>
For a diagnostics PROM, enter:
prom -v
<volume_no.>
: [frediag.exe | asndiag.exe | andiag.exe |
arndiag.exe]
<slot_ID>
The system verifies that the PROM image on a designated flash volume (that
is, the image file used as a source for upgrading the PROM) matches the
image actually stored in the boot or diagnostics PROM, on a designated slot.
When you use the -v option, the console displays one of the following
messages after the verification terminates:
prom: slot <slot ID> completed successfully
prom: PROM data does not match file data on slot <slot ID>
If the operation succeeds, the new images stored in the Boot and Diagnostic
PROMs run when you reboot the router.
If the operation fails, the console displays a message describing the cause of
the failure.
For additional examples of using the
prom command to update and verify
PROMs, see Using Technician Interface Software.
Upgrading PROMs in a Router from a Remote Site
This section summarizes the procedure for upgrading PROMs in a router that is
located in a remote site. Be sure to read the special considerations in this section
before upgrading router PROMs remotely.
Caution: If the PROM upgrade process is interrupted, the router could be
disabled.
Page view 65
1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 109 110

Comments to this Manuals

No comments