T1/FT1 Adapter Module
Supplement
2-2
118943-B Rev 00
Figure 2-1. T1/FT1 Adapter Module Cable Connection
You install the T1/FT1 adapter module in one of the two front-panel WAN adapter
module slots (Figure 2-1). See Installing and Operating BayStack ARN Routers.
Completing Software Configuration
Once you have successfully installed the adapter module, complete the following
software configuration tasks using instructions found in your BayRS
documentation:
Configuration Task Location of Instructions
Connect the ARN to the network.
Note that you cannot perform a Netboot or
Directed Netboot operation using the
T1/FT1 adapter module interface. The boot/
startup methods you can use are Local
Boot and EZ-Install.
One of the following:
• Installing and Operating BayStack ARN
Routers
• Configuring BayStack Remote Access
Modify the ARN configuration file to add the
T1/FT1 module and enable default software
services.
One of the following:
• Configuring and Managing Routers with
Site Manager
• Using the Bay Command Console
(BCC)
Configure T1 or FT1 services.
Configuring WAN Line Services
ARN0090A
1
2
ARN front panel
T1/FT1
DSU/CSU
Complies with FCC Rules Part 68
Reg. Number 4P8USA-31445-DE-N
To
T1 device
Comments to this Manuals