Avaya Configuring Data Encryption Services User Manual Page 25

  • Download
  • Add to my manuals
  • Print
  • Page
    / 62
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 24
117386-A Rev. A 2-1
Chapter 2
Implementation Notes
This chapter describes special issues that you may encounter in configuring and
running encryption.
Requirements for Enabling Encryption
To configure encryption, you must configure WEP parameters and either Frame
Relay or PPP encryption parameters. You must enable encryption for both the line
and circuit WEP parameters, and for either Frame Relay or PPP.
If you enable encryption for the line and circuit, but not for a protocol, data does
not travel over the network.
If you enable encryption for the line, circuit, and protocol, and some other
attribute for encryption is misconfigured, WEP drops data rather than sending it
unencrypted.
Selecting Encryption Strength
Both sides of a link must use the same encryption strength. Note that you can
select both encryption strengths, enabling a router that has 56-bit encryption
strength to use 40-bit encryption with a router that has only 40-bit encryption.
Page view 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 61 62

Comments to this Manuals

No comments