Avaya SIP Software 3.2 for 1200 Series User Manual download pdf (Page 87)

Chapter 8: Install the IP Deskphone

Complete instructions to install the Avaya 1200 Series IP Deskphone, including detailed figures and

applicable warnings, are given in the Avaya IP Deskphones User Guides.

The steps for installing the Avaya 1200 Series IP Deskphone are summarized in the following

procedure.

Installing the IP Deskphone

1. Remove the stand cover. Pull upward on the center catch and remove the stand cover. The

cable routing tracks are now accessible.

2. Connect the AC power adapter (optional). Connect the adapter to the AC adapter jack in the

bottom of the IP Deskphone. Form a small bend in the cable, and then thread the adapter cord

through the channels in the stand.

3. Install the handset. Connect the end of the handset cable with the short straight section into

the handset. Connect the end of the handset cable with the long straight section to the back of

the IP Deskphone, using the RJ-9 handset jack. Form a small bend in the cable, and then

thread the handset cord through the channels in the stand so that it exits behind the handset

on the right side, in the handset cord exit in the stand base.

4. Install the headset (optional). If installing a headset, plug the connector into the RJ-9 headset

jack on the back of the IP Deskphone, and thread the headset cord along with the handset cord

through the channels in the stand, so that the headset cord exits the channel.

5. Install the Ethernet cable. Connect one end of the supplied Ethernet cable to the back of the

IP Deskphone using the RJ-45 connector and thread the network cable through the channel.

6. Install the Ethernet cable connecting the PC to the IP Deskphone (optional). If connecting PC

Ethernet through the IP Deskphone, connect one end of the PC Ethernet cable to the

IP Deskphone using the RJ-45 connector and thread it through the channel. Connect the other

end to the LAN connector on the back of the PC.

7. Install additional cables. Connect the Ethernet cable to the LAN Ethernet connection. If using

an AC power adapter, plug the adapter into an AC outlet.

8. Wall-mount the IP Deskphone (optional). The IP Deskphone can be mounted either by: (method

A) using the mounting holes on the bottom of the IP Deskphone stand, or (method B) using a

traditional-style wall-mount box with RJ-45 connector and 15-cm (6-inch) RJ-45 cord (not

provided).

9. Replace the stand cover. Ensure that all cables are neatly routed and press the stand cover

into place until a click is heard.

10. Put the IP Deskphone in the wall-mount position (optional). If the IP Deskphone is to be

mounted on the wall, put it in the wall-mount position by holding the tilt lever and pressing the

IP Deskphone towards the base until the IP Deskphone is parallel with the base. Release the

tilt lever and continue to push the IP Deskphone towards the base until an audible click is

heard. Ensure the IP Deskphone is securely locked in position.

SIP Software for Avaya 1200 Series IP Deskphones-Administration January 2012 87

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 319 320

No comments

Avaya SIP Software 3.2 for 1200 Series User Manual Page 87