Avaya T7406E Configuration Guide download pdf (Page 41)

Chapter 4 Registering, deregistering, and resetting handsets 41

T7406E Cordless Handset Installation and Configuration Guide

Registering a handset

You must assign the port ID to the handset before you can register the handset. If you do not assign

a port ID to the handset first, the Please Register! message appears on the LCD. Make sure

the base station is in idle mode and the handsets are in idle mode before you start this procedure.

You must pair the handsets with a base station by registering the handsets. When you register a

handset, you establish a link between that handset and the base station. Registering a handset

prevents illegal use of or interception of conversations on the handset. Each time you register a

handset with the base station, the system generates a random secret code and sends it to that

handset.

Refer to Appendix A, “DIP switch settings” for the correct DIP switch settings.

1 Remove the power cord from the back of the base station.

2 Set the DIP switches at the back of the base station to registration mode.

If you do nothing with the handset for more than 30 seconds when the system is in registration

mode, the system returns automatically to normal operation mode without you having to

change the DIP switches.

3 Log on to the Maintenance menu.

4 Use the up and down softkeys to navigate to the Registration option.

5 Press Select.

6 Use the up and down softkeys to navigate to the Yes option.

7 Press Select to register the phone.

The Please Wait! message appears on the LCD.

8 Plug the power source back into the base station.

The base station power LED blinks rapidly.

9 After 5 seconds, the base station enters registration mode.

10 Place the handset near the base station.

If you successfully registered the handset the Registered! message appears in the LCD. If

you did not register the handset successfully, the Failed! Try Again! message appears.

Repeat steps 1 through 10.

You return to the top of the Maintenance menu.

11 Remove the power source from the base station.

Caution: Risk of service disruption

Always make sure that there are no TCM lines connected between the KSU and

the base station when the base station is in registration mode, or when you are

registering a handset.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 57 58

No comments

Avaya T7406E Configuration Guide Page 41