Avaya R2 Installation Guide download pdf (Page 79)

Installing the Data Module, Hardware Key, and Remote Maintenance Line

3-10 Installing the Data Module

Installing an 8400B Plus Data Module with a

Telephone

This section describes the equipment you need to install an 8400B Plus Data

Module with a telephone and the steps you must follow to prepare it to

operate. The 8400B Plus comes with the default option set to be used with a

telephone.

To install an 8400B Plus Data Module, you will need the following:

• One 8400B Plus Data Module.

• One EIA-232 cable.

• One D8W cord.

• If Data Module power is not available through the phone jack, you will

also need one 8400B Plus Data Module power supply.

• If a KS-22911 power supply is used, you will need a 400B2 adapter.

• If an MSP-1 power supply is required, you will also need an extra D8W

cord.

• If the communications port on the PC has nine pins, you will need an

M25/F9 adapter.

Selecting an EIA-232-D Cable 3

Select an EIA-232-D with a male connector at one end to connect to the

Port 1 connector of the 8400B Plus, and a connector of the appropriate

gender at the other end to connect to the communications port of your PC.

Cables with an earlier RS-232-C designation will also work.

Connecting the EIA-232-D Cable 3

Connect the EIA-232-D cable between the 8400B Plus and the PC as follows:

1. Insert the male connector of the EIA-232-D cable into the connector

labeled “Port 1” on the rear panel of the 8400B Plus. Tighten both

connector retaining screws.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 146 147

No comments

Avaya R2 Installation Guide Page 79