114113-B Rev. 00
A-1
Appendix A
Configuring the AN or ANH
for Netboot and Directed Netboot
This appendix describes how to configure an AN or ANH router for Netboot and
Directed Netboot and contains the following topics:
The
ifconfig
and
bconfig
commands configure the AN or ANH for Netboot and
Directed Netboot:
• Use the
i
fconfig
command to configure the AN/ANH router’s initial IP
interface to the network. You need this information to complete the procedure
in “Continuing with Netboot” in Chapter 3.
• Use the
bconfig
command to specify the location and name of the AN/ANH
software image and configuration file. You need this information to complete
the procedure in “
Continuing with Directed Netboot” in Chapter 3.
Contact your network administrator for additional assistance in determining the
appropriate
ifconfig
and
bconfig
commands you need for the AN or ANH at your
site. (Your network administrator has information about these commands in
Configuring BayStack Remote Access.)
Topic Page
Using the ifconfig Command
A-2
Enabling and Disabling Interfaces with ifconfig A-5
Using the bconfig Command A-6
Comments to this Manuals