Avaya BayStack AN and ANH Routers User Manual download pdf (Page 68)

Installing and Operating BayStack AN and ANH Routers

2-10

114113-B Rev. 00

Mounting the ANH on a Wall

For this procedure, you need the following items:

• Two flange brackets and four #6 roundhead screws (shipped with the ANH)

• Four to eight wall anchor screws (not shipped with the ANH)

• Phillips screwdriver

To mount the ANH on a wall:

Attach a flange bracket to each side of the ANH as follows:

With the longer bracket piece lying flat, align the holes in the shorter

end of the bracket with two of the mounting holes on the side of the

ANH (Figure 2-6).

Insert a screw through each hole and into the ANH.

Tighten the 4 screws with a Phillips screwdriver.

Figure 2-6. Attaching Flange Brackets to Install the 8-Port ANH on a Wall

Place the ANH with installed brackets against the wall to determine the

location of the anchor screws (Figure 2-7).

Note:

The sides of the ANH include screw holes at both ends, providing three

ways to attach the brackets for wall-mounting. You can attach both brackets

toward the front of the ANH, both brackets toward the back, or you can offset

the two brackets, as shown in Figure 2-6, for the most secure installation.

Screws

(2 places)

Screws

(2 places)

Access Node Hub

Front of ANH

Back of ANH

AN0042A

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 183 184

No comments

Avaya BayStack AN and ANH Routers User Manual Page 68