Avaya BayStack AN and ANH Routers User Manual Page 70

  • Download
  • Add to my manuals
  • Print
  • Page
    / 184
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 69
Installing and Operating BayStack AN and ANH Routers
2-12
114113-B Rev. 00
3.
Insert 2 to 4 wall anchor screws through the holes in each flange bracket,
and fasten each screw securely in the wall.
Connecting Communications Cables
Gather the communications equipment and cables that you will attach to the
ANH. If you do not have the proper cables, contact your network administrator or
see the Cable Guide. Appendix C describes the ANH cable interfaces.
Connecting an AUI Cable
To connect an Ethernet AUI transceiver cable to the front of the ANH:
1.
Connect an Ethernet AUI drop cable to the port labeled AUI (Figure 2-8).
The cable must have a female 15-pin D-SUB connector.
Figure 2-8. Connecting an AUI Cable
2.
Secure the AUI cable using the connector slide lock.
3.
Connect the other end of the cable to the transceiver device.
Caution:
Connecting the ANH AUI port directly to the AUI port on an
Ethernet station violates IEEE 802.3 standards. The AUI port is designed only
for connection to a transceiver.
Reset
Partition
Link
12345678
1 234 5678
Console
Power
Fault
Boot Run DCM AUI Part
DCD1 DCD2 <LAN> Col
AUI
MDI-X/MDI
MDI-X
AUI cable
AUI interface
Access Node Hub
AN0044A
Page view 69
1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 183 184

Comments to this Manuals

No comments