Configuring BayStack Remote Access
6-14 117341-A Rev. A
Consider the following when changing DCM configuration parameters:
• Set the value of wfDCMmw.wfDCMmwCfgMode.0 to
DCMMW_CFG_LOAD_SHMEM before changing other object values.
• After changing any DCM object values, reboot by disabling and then enabling
the DCM to initialize the changes.
• To apply a configuration change after rebooting the DCM, set the
wfDCMmwWriteConfigInfo parameter to DCMMW_CFG_WRITE so the
DCM saves the new information to its flash memory.
RMON Implementation Notes
Read the following sections to learn about the issues you should consider when
using RMON network management applications with the DCM:
• Har
dware and Software Compatibility
• RMON Applications
• RMON Memory Use
• Interoperability Issues and Memory Use for RMON Groups
These sections assume that you have a good understanding of each RMON group
and the RMON MIB objects. See “RMON Gr
oups” on page 6-3 and RFC 1757
for information about each RMON group.
Hardware and Software Compatibility
Table 6-1 lists the minimum and recommended versions of software required for
RMON operation on BayStack AN and ANH routers.
Table 6-1. AN/ANH Requirements for RMON
Minimum Version Recommended Version
BayRS Version 9.0 BayRS Version 11.0 (
an.exe
v11.0) or later
DCM Agent Software Version 1.4 DCM Agent Software Version 1.4.2 (
in11_142.obj
)
Comments to this Manuals