Configuring BayStack Remote Access
4-10 117341-A Rev. A
Verifying Your Configuration
You can use the getcfg command to verify the following:
• Whether the router is set to boot using a local or remote boot image
• Whether the router is set to configure using a local or remote configuration file
• The configuration of the synchronous, Ethernet, and token ring (ARN only)
interfaces
To display the configured startup options for a BayStack router, enter the
following command at the Technician Interface or AN Monitor prompt:
getcfg
The following sample output shows the default configuration for an AN/ANH
with one Ethernet interface and two synchronous interfaces:
Boot Options
boot image=local
boot config=network
Netboot Parameters:
XCVR1..None
COM1...EZ-Install
COM2...EZ-Install
The following sample output shows the configuration for an ARN with one
Ethernet interface, one token ring interface, and five synchronous interfaces:
Boot Options
boot image=local
boot config=network
Netboot Parameters:
MAU1...None
XCVR2..None
COM1...EZ-Install
COM2...EZ-Install
COM3...EZ-Install
COM4...EZ-Install
COM5...EZ-Install
Comments to this Manuals