Configuring BayStack Remote Access
6-10 117341-A Rev. A
Booting the DCM
You can use Site Manager to reboot the DCM.
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose Platform.
The Platform menu opens.
2. Choose DCM 11.0 and later. The DCM 11.0 and Later menu opens.
3. Choose Create Base Module DCM.
For the ARN only, you can enable a DCM
on both an Ethernet base module and an
Ethernet expansion module. To create the
DCM software subsystem on an ARN
expansion module with an installed DCM,
choose Create Expansion Module DCM.)
The Edit Base Module DCM Parameters
window opens.
If you chose Create Expansion Module
DCM for an ARN, the Edit Expansion
Module DCM Parameters window opens,
with parameters identical to those in the
Edit Base Module DCM Parameters
window.
4. Set the Enable/Disable parameter to
Disable. Site Manager
: Enable/Disable
parameter: page A-10.
5. Click on OK. You return to the Configuration Manager
window.
6. Repeat steps 1 through 3. The Edit Base Module DCM Parameters
window reopens.
7. Set the Enable/Disable parameter to
Enable. Site Manager: Enable/Disable
parameter: page A-10.
8. Click on OK. You return to the Configuration Manager
window.
Comments to this Manuals