Avaya BCM1000 Installation Manual download pdf (Page 203)

Chapter 16 Replacing the hard disk 177

Installation and Maintenance Guide

Installing a new hard disk

This section describes what you need to do to install a new hard disk into the BCM1000.

Follow these steps to replace hard disks into the brackets, and then, back into the base unit

housing.

1 Ensure you have followed the directions in “Removing the hard disk” on page 174.

2 Attach the new hard disk to the brackets, positioning the hard drive so the exposed electronic

components face down. Refer to Figure 80.

Figure 80 Connect the brackets to the hard disk (single-disk system)

Figure 81 Installing two hard disks for a mirrored disk system

Note: Mirrored disk note

In a mirrored disk system, the Primary system disk is always installed in the bottom level

of the brackets.

If you are upgrading to a mirrored disk system, position the new hard disk (Mirror

Primary) over the existing hard disk, between the tall brackets. There will be a space

between the hard disks. Refer to Figure 81 on page 177.

Note: If you are replacing a failed disk on a mirrored disk system, ensure the new disk is

replaced in the same position in the bracket that the failed disk was removed from.

Single-disk bracket

Mirrored hard disk

Primary hard disk

Note space

between hard

disks

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 310 311

No comments

Avaya BCM1000 Installation Manual Page 203