Avaya BCM1000 Installation Manual download pdf (Page 95)

Installation and Maintenance Guide

Chapter 5

Installing the BCM1000

This chapter describes how to install the BCM1000.

Preparation checklist

Before you install the base unit, complete the following actions.

• Determine the location for the BCM1000, telephones, and other equipment based on spacing

and electrical requirements. For more information about spacing and electrical requirements,

refer to the “Environment checklist” on page 69 and the “Electrical requirements” on page 70.

• Order the required trunks from the central office.

• Ensure that you have all the equipment and supplies you require to install the system. Refer to

“System equipment and supplies” on page 71.

• If you want to install the media bay modules into the BCM1000 before you install it, ensure

that the DIP switches are set correctly. Refer to Chapter 4, “Selecting the media bay modules

for your system,” on page 59 and Chapter 8, “Installing media bay modules,” on page 109.

Environment checklist

The installation area must be:

• minimum of 4 m (13 ft) from equipment such as photocopiers, electrical motors and other

equipment that produces electromagnetic, radio frequency and electrostatic interference

• within 1.5 m (5 ft.) of a three-wire grounded electrical outlet

• clean, free of traffic and excess dust, dry and well ventilated

• within the temperature ranges of 0°C and 40°C (32°F and 95°F)

• between 20% and 80% non-condensing relative humidity

• enough space and strength to support the BCM1000

• minimum of 46 cm (18 in.) from the floor

Note: The installation area must be of sufficient height from the floor to prevent water

damage.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 310 311

No comments

Avaya BCM1000 Installation Manual Page 95