Avaya BCM1000 Installation Manual download pdf (Page 271)

Defining region-based defaults 245

Installation and Maintenance Guide

BRI and PRI line types

The following table provides a description of the types of lines that BRI and PRI trunks

can provide. These are set under Resources, Media Bay Modules, Bus XX, Module X on

the Unified Manager.

Note that some of these line types are only available when specific regions are chosen.

Table 58 BRI and PRI line types (DTM and BRI modules)

Digital trunk types Description

T1 digital line that carries data on 24 channels at 1.544 Mbps (North American); 30 channels

at 2,048 Mbps (Europe)

Loop, E&M, DID and ground start trunks are also versions of T1 lines.

You can program auto-answer T1 loop start, T1 E&M trunks, T1 DID, T1 ground start

trunks, PRI and IP trunks to map to target lines to provide for attendant bypass (calling

directly to a department or individual) and line concentration (one trunk can map onto

several target lines).

DID This is a type of T1 trunk line that allows an outside caller to dial directly into a line on the

Business Communications Manager 2.5.

Loop This is a type of T1 line. This type of line is used on systems where the service provider

supports disconnect supervision for the digital loop start trunks.

These trunks provide remote access to the Business Communications Manager from the

public network. This trunk must have disconnect supervision to allow the trunk to be set to

auto-answer, which provides the remote access portal.

Ground T1-groundstart trunk

These lines offer the same features as loop start trunks, but are used when the local

service provider does not support disconnect supervision for digital loop start trunks.

Ground start trunks work with T1 only. By configuring lines as ground start, the system will

be able to recognize when a call is released at the far end.

E&M T1 and E&M. This type of trunk line is used to create simple network connections to other

phone systems.

This trunk always operates in a disconnected supervised mode.

PRI ISDN interface with 23 B channels and 1 D channel at 1.544 MBps (in Europe: 30 B

channels and 2 D channels at 2.048 Mbps)

This is the module that controls system timing.

These lines give you incoming and outgoing access to an ISDN network and are

auto-answer trunks, by default.

These lines provide a fast, accurate and reliable means of sending and receiving data,

images, text and voice information. using PRI lines allows for faster transmission speeds

and the addition of a variety of powerful business applications, including remote LAN

access, video conferencing, file transfer and internet access.

BRI ISDN loop that provides both T, S and U2 and U4 (region-specific) reference point loops.

These loops can support both network (T and S loops) and terminal equipment (S loop)

connections.

This type of line provides incoming and outgoing access to an ISDN network. ETSI ISDN

BRI is the European Telecommunications Standards Institute specification for BRI ISDN

service. BRI provides two bearer B-channels operating at 64 kbits/s and a data D-channel

which operates at 16 kbits/s. The D-channel is used primarily to carry call information. Like

loop start trunks, BRI lines can be configured as manual-answer or auto-answer.

DASS2 (British) Trunk provides multi-line IDA interconnection to the British Telecom network.

1 2 ... 266 267 268 269 270 271 272 273 274 275 276 ... 310 311

Comments to this Manuals

No comments

Avaya BCM1000 Installation Manual Page 271

Comments to this Manuals