Avaya BCM1000 Installation Manual download pdf (Page 256)

230 Chapter 20 Moving and replacing telephones

N0008587 01

Moving telephones

You can move an Business Communications Manager digital telephone to a new location within

the system without losing its programmed settings if the telephone has been enabled with

Set relocation in system programming under Feature programming. When you enable Set

relocation (automatic telephone relocation), the internal numbers, autodial settings, and personal

speed dial codes remain with the telephone when you disconnect the telephone.

If you connect a different telephone to the jack before you reconnect the moved telephone, the new

telephone takes the programmed settings. The Business Communications Manager system can no

longer identify the old telephone.

After you plug a moved set into a new jack, the Business Communications Manager system can

take 45 seconds to identify the telephone. Programming relocation takes three minutes to

complete. Wait for this to occur before you change any settings for the telephone in the system.

For IP telephones to retain features, the Keep DN Alive setting for the telephone programming

must be set to Yes in system programming on the Capabilities screen in the DN record for the

telephone.

Warning: If you disconnect a relocated telephone before the relocation programming is

complete, the telephone can lose the programmed settings.

Note: Automatic telephone relocation is disabled by default.

1 2 ... 251 252 253 254 255 256 257 258 259 260 261 ... 310 311

No comments

Avaya BCM1000 Installation Manual Page 256