Editing DLSw Parameters
5-23
2. Type a value for the Slot parameter.
3. Type the IP address of an interface configured earlier on the router.
Each DLSw-capable slot requires its own IP interface in the router
configuration. Do not specify the same IP interface address for two or more
different DLSw-capable slots in the same router configuration.
4. Click on OK to save your entry to the configuration file.
The DLSw Slot Configuration window reappears (refer to Figure 5-11) with
the new entry added to the list of existing DLSw-capable slots.
Following are descriptions of the DLSw Slot IP Table parameters.
Parameter: Slot
Default: None
Range: 1 to 14
Function: Specifies the slot number you want to associate with the IP interface
address you reserved for that slot.
Instructions: Type a slot number from 1 to 14, depending on
• Type of node/chassis
• Slots that link modules can occupy
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.5.3.1.2
Parameter: IP Address
Default: None
Options: Any valid, 32-bit IP address in the form network.host in dotted decimal
notation
Function: Specifies an IP address associated with a specific DLSw peer (slot) in the
router. TCP uses this IP address for connections associated with that slot.
Instructions: Type a valid IP address for the slot. The IP interface need not reside on the
DLSw-capable slot. Do not enter a value for every active slot in the router.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.5.3.1.3
Comments to this Manuals