Customizing DVMRP
117355-C Rev 00
4-49
Disabling and Reenabling a Tunnel
When you configure a tunnel on an interface, the tunnel is enabled by default. You
can use the BCC or Site Manager to disable and reenable the tunnel.
Using the BCC
Navigate to a DVMRP tunnel prompt and enter:
state
<state>
state
is one of the following:
enabled
(default)
disabled
For example, the following command disables DVMRP tunnel 2.3.4.5./4.4.2.3:
dvmrp/2.3.4.5/4.4.2.3#
state disabled
dvmrp/2.3.4.5/4.4.2.3#
Using Site Manager
To disable and reenable a tunnel:
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose
Protocols
.
The Protocols menu opens.
2. Choose
IP
. The IP menu opens.
3. Choose
DVMRP
. The DVMRP menu opens.
4. Choose
Tunnel
. The DVMRP Tunnel Parameters window
opens.
5. Set the
Enable
parameter. Click on
Help
or see the parameter description on page
A-12.
6. Click on
Apply
, and then click on
Done
. You return to the Configuration Manager
window.
Comments to this Manuals