Avaya Configuring IP Multicasting and Multimedia Services User Manual download pdf (Page 117)

Customizing DVMRP

117355-C Rev 00

4-59

Accepting a Report from a Nonstandard DVMRP Neighbor

By default, DVMRP does not accept a report from a nonstandard DVMRP

neighbor.

A standard DVMRP router does not advertise a route report before sending a

probe message to a neighbor. DVMRP uses the probe message to learn the

neighbor’s capability. Some routers, however, send only route reports; they do not

send probes.

If you want DVMRP to communicate with nonstandard DVMRP routers, be sure

to set the Report Depend Probe parameter to Enable. You can use the BCC or Site

Manager to enable and disable this feature as required.

Using the BCC

Navigate to a DVMRP tunnel-specific prompt and enter:

depend-on-probe

<state>

state

is one of the following:

enabled

disabled

(default)

For example, the following command configures DVMRP to communicate with a

nonstandard DVMRP neighbor on tunnel 2.2.2.2/4.4.3.2:

tunnel/2.2.2.2/4.4.3.2#

depend-on-probe enabled

tunnel/2.2.2.2/4.4.3.2#

1 ... 116 117 118 ... 278

No comments

Avaya Configuring IP Multicasting and Multimedia Services User Manual Page 117