Avaya P332G-ML User Manual download pdf (Page 101)

Chapter 12 Avaya P330 Layer 3 Features

Avaya P332G-ML User’s Guide 87

Assigning Initial Router Parameters

This section is only applicable if you either purchased a Layer 3 preconfigured

P332G-ML module or purchased a Routing License Key Certificate for P332G-ML

and activated the License Key. For information, on activating a Licence Key, see

Obtaining and Activating a License Key below.

To configure the initial router parameters perform the following via the CLI:

1Enter set device-mode router and press Enter.

You will be prompted to reset the module.

2Type y.

Wait for the module to restart and for the CLI prompt to reappear.

3Type show device-mode and press Enter to ensure that the module is in

router mode.

Note: Assign the stack IP address as described in Assigning P330’s IP Stack Address

before you assign the Initial Router IP address.

4 To access Router commands from the Master module, type the command

session <module number> router where <module number> is the

location of the router module in the stack, and press Enter.

The command prompt changes from P330-N> to Router-N#> where N is

the number of the router in the stack (see P330 Sessions).

5Type configure and press Enter. The prompt Router-N(configure)#

appears.

Use this command before

configuring VLAN-oriented

parameters, when there is more

than one interface on the same

VLAN

enable vlan commands

Display information about the IP

unicast routing table

show ip route (Layer 3)

Display information for an IP

interface

show ip interface

Display the status of ICMP error

messages

show ip icmp

Delete a Layer 2 Router interface clear vlan

In order to... Use the following command...

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 149 150

No comments

Avaya P332G-ML User Manual Page 101