Avaya P332G-ML User Manual download pdf (Page 49)

Chapter 7 Establishing Switch Access

Avaya P332G-ML User’s Guide 35

4 At the prompt, type:

set interface inband <vlan> <ip_address> <netmask>

Replace <vlan>, <ip_address> and <netmask> with the VLAN,

IP address and net mask of the stack.

5 Press Enter to save the IP address and net mask.

6 At the prompt, type reset and press Enter to reset the stack. After the Reset,

7 At the prompt, type set ip route <dest> <gateway> and replace <dest>

and <gateway> with the destination and gateway IP addresses.

8 Press Enter to save the destination and gateway IP addresses.

Establishing a Telnet Connection

Perform the following steps to establish a Telnet connection to the Avaya P330 for

configuration of Stack or Router parameters. You can Telnet the Stack Master IP

address:

1 Connect your station to the network.

2 Verify that you can communicate with the Avaya P330 using Ping to the IP of

the Avaya P330. If there is no response using Ping, check the IP address and

default gateway of both the Avaya P330 and the station.

Note: The Avaya P330 default IP address is 149.49.32.134 and the default subnet

mask is 255.255.255.0.

3 From the Microsoft Windows

taskbar of your PC click Start and then Run (or

from the DOS prompt of your PC), then start the Telnet session by typing:

telnet <P330_IP_address>

If the IP Address in Telnet command is the IP address of the stack, then

connection is established with the Switch CLI entity of the Master module.

When you see the “Welcome to P330” menu and are prompted for a Login

Name, enter the default name root

4 When you are prompted for a password, enter the User Level password root

in lower case letters (do NOT use uppercase letters). The User level prompt will

appear when you have established communications with the Avaya P330.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 149 150

No comments

Avaya P332G-ML User Manual Page 49