Chapter 8 Installing an expansion unit 103
BCM50 Installation and Maintenance Guide
Installing the expansion unit
Make sure that the expansion unit is installed close enough to the main unit so that the supplied
expansion cable can be connected between the expansion unit and main unit.
The expansion unit can be mounted in a rack, on a wall, or on a desktop. Typically, the expansion
unit is mounted in the same way as the main unit.
Use one of the following procedures to mount the expansion unit:
• Installing the BCM50 unit in an equipment rack on page 84
• Installing the BCM50 unit on the wall on page 88
• Installing the BCM50 unit on a desktop or shelf on page 93
Next step
If you install a second expansion unit on the system, repeat the procedures in this section for the
second expansion unit.
After you install the expansion unit, proceed to Connecting the cables to the BCM50 system on
page 105.
Comments to this Manuals