Avaya BCM50 Installation Manual download pdf (Page 146)

146 Chapter 14 Using Element Manager to set the basic parameters

NN40170-305

4 Configure the IP Terminal Global Settings attributes. See the table IP Terminal Global

Settings attributes on page 146.

You can configure other attributes on the IP Terminal Global Settings tab depending on the

requirements for your system.

To configure SNMP settings

1 From the Configuration tab, click the Administrator Access folder to expand it.

2 From the Administrator Access folder, select SNMP.

3 Select the General tab. It is normally selected by default.

4 From the SNMP Settings area, click Modify.

The Modify SNMP Settings dialog box appears.

Table 26 IP Terminal Global Settings attributes

Attribute Description

Enable registration Select this check box to allow new IP clients to register with the system.

WARNING: Remember to clear this check box when you finish registering the

new telephones.

Enable global registration

password

To require the installer to enter a password when IP telephones are configured

and registered to the system, select this box.

If this box is not selected (disabled), a valid Telset user ID and password is

required to register IP phones.

Global password If you select the Enable Global Registration Password check box, enter the

password the installer enters on the IP telephone to connect to the system.

If this check box is empty, no password prompt occurs during registration.

Auto-assign DNs If you select this check box, the system assigns an available DN as an IP

terminal requests registration. It does not prompt the installer to enter a set

DN.

If this check box is empty, the installer receives a prompt to enter the assigned

DN during the programming session.

Advertisement/Logo Any information in this field appears on the display of all IP telephones. For

example, your company name or slogan (24 characters in length).

Tip: To automatically configure IP Phones with DNs assigned:

1) Select the Enable registration check box.

2) Select the Enable global registration password check box.

3) Leave the Global password field blank.

4) Select the Auto-assign DNs check box.

After the IP Phones are operational, clear the Enable registration check

box.

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 294 295

No comments

Avaya BCM50 Installation Manual Page 146