Avaya BCM50 Installation Manual Page 186

  • Download
  • Add to my manuals
  • Print
  • Page
    / 295
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 185
186 Chapter 22 Replacing a media bay module
NN40170-305
To remove the MBM
1 Use Element Manager to disable the MBM. For more information about disabling an MBM,
see the Administration Guide.
2 If the expansion unit is wall-mounted, it must be removed from the wall-mount bracket before
you remove the MBM. For more information, see the procedure To remove a wall-mounted
expansion unit on page 191, and then proceed to step 7.
3 Disconnect all of the telephone line and extension cables from the MBM.
If more than one cable exists, mark the cables to identify the port from which you removed
them.
4 Rotate the power supply retention clip to free the power supply cord.
5 Remove the power supply cord from the expansion unit.
6 Attach one end of the grounding strap to your wrist and the other end to a grounded metal
surface.
7 Pull out the ejector lever with your index finger. Then grasp the ejector lever with your thumb
and index finger and pull outward to disengage the MBM. See the figure Pull out the ejector
lever with your index finger. Then grasp the ejector lever with your thumb and index finger
and pull outward to disengage the MBM. See the figure Pull out the ejector lever with your
index finger. Then grasp the ejector lever with your thumb and index finger and pull outward
to disengage the MBM. See the figure . Finish removing the MBM by hand. on page 186.
Finish removing the MBM by hand. on page 186. Finish removing the MBM by hand.
Figure 74 Remove an MBM
8 Grasp the top and bottom edges of the MBM. Remove the MBM from the expansion unit.
Place the MBM on a flat, clean, static-free surface.
9 Continue with the procedure To insert the new MBM on page 187.
Warning: Protect the hardware components against damage from electrostatic
discharge. Always wear a ground wrist strap before you handle components. Always
place the components in a static-free container.
Grasp the edge of the MBM
ejector lever and pull outward
Page view 185
1 2 ... 181 182 183 184 185 186 187 188 189 190 191 ... 294 295

Comments to this Manuals

No comments