Avaya BCM50 User Manual download pdf (Page 65)

BCM50 System Start Up

NN40010-318 Issue 1.2 BCM50 Rls 6.0 65

Connecting the BCM to the Network

NOTE: If the BCM is in a Standalone Installation, this section should be

ignored.

After the BCM has been prepared for the network, and the preceding

initialisation procedures have been performed, the BCM can be connected to

a Local Area Network (LAN).

1. Plug one end of a standard RJ45 patch cable into one of the LAN ports

of the BCM. Plug the other end of the cable into a network connection

point, e.g. a wall mounted RJ45 socket, or directly into a switch/hub.

Registering IP Terminals

The following procedure describes how to configure the BCM to allow IP

Telephones to register on the BCM.

Note: For full instructions on how to register and set up IP terminals, including

Remote worker sets, refer to the IP Telephony Guide.

1. From the Configuration tab, open the Resources folder to expand it.

2. Select Telephony Resources from the Resources folder.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 81 82

No comments

Avaya BCM50 User Manual Page 65