BCM50 System Start Up
NN40010-318 Issue 1.2 BCM50 Rls 6.0 75
DHCP Server
If Server is set to Enabled, you can specify the Default Gateway, DHCP
Domain, and DNS Servers that will be issued to DHCP Clients
Enable or Disable the core DHCP Server.
Enter the Default Gateway on the network
Domain name for the DHCP Server
Enter the Fully Qualified Domain Name or IP Address of the Primary DNS
Server (if known)
Enter the Fully Qualified Domain Name or IP Address of the Secondary
DNS Server (if known)
IP Address
These settings relate to the LAN interfaces.
Select Enabled to automatically receive an IP Address etc., or Disabled to
specify a static address, subnet mask and default gateway.
Enter the required IP Address of the LAN 1 interface.
Enter the required Subnet Mask for the LAN 1 interface.
Enter the Default Gateway for the LAN 1 interface.
Modem
Select whether or not to enable the software modem, which can be used for
Remote Dial-in purposes.
Keycodes
If you have received a Keycode file and wish to apply it using the Startup
Profile, enter the name of the file here. The Keycode file must be located in
the root of the USB drive
Telephony Startup Settings
DID: Systems configured using the DID template, automatically assign
target lines to all DNs. Use this template if DDI numbers are used.
PBX: Pool A is automatically assigned for all DNs. Use this template in
situations where calls are routed through an operator.
Enter the first extensions number for your system.
IP Telephones
Enabled or Disable IP Set registration
If Yes, the IP set installer will have to enter the password set in the Global
Password field
If using Global Password, enter a password for the IP set installer to enter
If Enabled, DNs will automatically be assigned to the IP sets
This is the display on the handset
Comments to this Manuals