Avaya P332G-ML User Manual download pdf (Page 112)

Chapter 12 Avaya P330 Layer 3 Features

98 Avaya P332G-ML User’s Guide

Static Routing Configuration CLI Commands

Route Preferences

The routing table may contain routes from different sources. Routes to a certain

destination may be learned independently from RIP and from OSPF, and at the

same time, a static route can also be configured to the same destination. While

metrics are used to choose between routes of the same protocol, protocol

preferences are used to choose between routes of different protocols.

The preferences only apply to routes for the same destination IP address and mask.

They do not override the longest-match choice. For example, a high-preference

static default route will not be preferred over a RIP route to the subnet of the

destination.

P330 protocol preferences are listed below from the most to the least preferred:

1 Local (directly attached net)

In order to... Use the following command...

Establish a static route ip route

Remove a static route no ip route

Set the maximum number of route

entries in the routing table

ip max-route-entries

Set the maximum number of route

entries in the routing table to the

default value

no ip max-route-entries

Define a default gateway (router) ip default-gateway

Remove the default gateway

(router)

no ip default-gateway

Delete all the dynamic routing

entries from the Routing Table

clear ip route

Display information about the IP

unicast routing table

show ip route

Display a routing table for a

destination address

show ip route best-match

Display the static routes show ip route static

Display the number of routes

known to the switch

show ip route summary

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 149 150

No comments

Avaya P332G-ML User Manual Page 112