Avaya P332G-ML User Manual download pdf (Page 25)

Chapter 3

Avaya P332G-ML User’s Guide 11

Installation

Installing and Removing a SFF/SFP GBIC Transceiver

Caution: Use only 3.3V Avaya-authorized SFF/SFP GBIC transceivers.

Use only SFF/SFP GBIC transceivers that use Serial Identification.

The SFF/SFP GBIC transceiver is fastened using a snap-in clip.

To Install the SFF/SFP GBIC transceiver:

• Insert the transceiver (take care to insert it the right way up) until it clicks in

place.

To Remove the SFF/SFP GBIC transceiver:

1 Press the clip on the bottom side of the transceiver.

2 Pull the transceiver out.

Specifications

LX Transceiver

A 9 µm or 10 µm single-mode fiber (SMF) cable may be connected to a 1000Base-LX

SFF/SFP GBIC port. The maximum length is 10 km (32,808 ft).

A 50 µm or 62.5 µm multimode (MMF) fiber cable may be connected to a 1000Base-

LX SFF/SFP GBIC port. The maximum length is 550 m (1,804 ft.) for

50 µm and 62.5 µm cable.

The LX transceiver has a Wavelength of 1300 nm, Transmission Rate of 1.25 Gbps,

Input Voltage of 3.3V, and Maximum Output Wattage of -3 dBm.

SX Transceiver

A 50 µm or 62.5 µm multimode (MMF) fiber cable may be connected to a 1000Base-

SX SFF/SFP GBIC port. The maximum length is 500 m (1,640 ft.) for

50 µm and 220 m (722 ft.) for 62.5 µm cable.

The SX transceiver has a Wavelength of 850 nm, Transmission Rate of 1.25 Gbps,

Input Voltage of 3.3V, and Maximum Output Wattage of -4 dBm.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 149 150

No comments

Avaya P332G-ML User Manual Page 25