Avaya P332G-ML User Manual download pdf (Page 37)

Chapter 4 Installation

Avaya P332G-ML User’s Guide 23

Making Connections to Network Equipment

This section describes the physical connections that you can make between the

Avaya P330 switch and other network equipment.

Prerequisites

Make sure you have the following before attempting to connect network equipment

to the P330 switch:

• a list of network equipment to be connected to the P330 switch, detailing the

connector types on the various units

• all required cables (see below). Appropriate cables are available from your local

supplier.

Connecting Cables to Network Equipment

P332G-ML modules include the following types of ports (according to the speed

and standard they support): SFP GBIC

To connect the cables:

1 Insert an SFP GBIC (Small Form Factor Plugable Gigabit Interface Converter)

transceiver (not supplied) to the port housing. For a list of approved SFP GBIC

transceivers, see www.avayanetwork.com. For fiberoptic cable properties, see

Table 4.4.

Note: GBICs are 3.3V.

2 Connect the Ethernet fiberoptic cable (not supplied) to the GBIC transceiver on

the front panel of the Avaya P332G-ML. You can use LC or MT-RJ fiberoptic

cables depending on the GBIC transceiver you are using.

3 Connect the other end of the cable to the Ethernet port of the PC, server, router,

workstation, switch, or hub.

4 Check that the appropriate link (LNK) LED lights up.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 149 150

No comments

Avaya P332G-ML User Manual Page 37