Avaya P580 User Manual download pdf (Page 709)

100

101

Avaya P550R, P580, P880, and P882 Multiservice Switch User Guide, v5.3.1 A-7

Upgrading the Application Software

The FEPROM Contents Web page is displayed in the

content pane (Figure A-183).

3. In the Power Up/Reset Image field, select the APP location

to which you downloaded the new application software.

4. Select APPLY.

CLI Command To set the switch to load the new software at startup, use the

following CLI command:

<configure># boot system flash {app1 | app2 | cardapp1 |

cardapp2}

For more information on this command, see Chapter 27, “System,”

in the Command Reference Guide for the Avaya P550R, P580, P880, and

P882 Multiservice Switches.

Synchronizing the Active and Standby

Supervisor Modules

If the switch has a redundant supervisor module, you must

synchronize the active and standby supervisor modules after you

upgrade the application software on the active supervisor module.

During this synchronization, the new boot code and application

software are copied to the standby supervisor module.

For information on how to synchronize the active and standby

supervisor modules, see “Synchronizing the Active and Standby

CPUs” on page 7-14.

CAUTION

The Avaya Multiservice Switch must have the same model

supervisors in slots 1 and 2 to support redundant supervisor

operation. Both Active and Standby CPUs app1 and app2

images must run 5.0 or greater software to support 80-series

Supervisor.

CAUTION

The Standby supervisor module must use the same boot code

as the Active Supervisor module and must be running in the

same Fabric mode.

CAUTION

When making configuration changes to the switch you must

save the changes you made by copying the running

1 2 ... 704 705 706 707 708 709 710 711 712 713 714 ... 759 760

Comments to this Manuals

No comments

Avaya P580 User Manual Page 709

Comments to this Manuals

Related products and manuals for Computer Accessories Avaya P580