Avaya BSGx4e CLI User's Guide download pdf (Page 16)

CLI command syntax 2 Command interface overview

16 NN47928-107

CLI command syntax

The following syntax applies to CLI commands:

config [command group] [command sub-group] [PK] [parameter <value>]

For a description of the syntax, see General help on page 13.

Enter a command group followed by a ?, to list all subcommand groups. For

example:

>config ids?

ids anomaly Anomaly based IDS prevention

ids flood activity IDS Flood protection

ids flood settings IDS Flood protection

ids scan IDS Scan protection

ids spoof IDS spoofing protection

Enter a command group and sub-command group and a ? to see the [PK]

and parameters associated with that sub-command. For example:

> config ids anomaly

attack Attack type to detect and drop

(fragoverlap|fragoverrun|fragtooshort)

active Whether or not attack detection is applied

(no | yes)

In the previous example, attack is a parameter and the values are

fragoverlap, fragoverrun, and fragtooshort. For detailed information

about parameters and values, see Parameter values on page 16

Parameter values

In general, a parameter is specified by its name followed by its value. For

example, port 2600 specifies the value

2600 for the port parameter.

The following lists exceptions for specifying parameter values:

z Primary Key

If the first parameter for a command is listed in brackets (such as

[name]), it is a primary key parameter and specifies the object of the

command. The primary key value is specified without its parameter

name.

For example, the first parameter of the command config ids spoof is

listed as [name] and the second parameter as type. When you enter the

command, specify just the value for the first parameter, but both the

name and its value for the second parameter.

> config ids spoof eth1 type trusted

z Booleans

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 183 184

No comments

Avaya BSGx4e CLI User's Guide Page 16