Avaya BSGx4e CLI User's Guide download pdf (Page 75)

3 Configuration commands Media gateway controller protocol commands

NN47928-107 75

mgcp ua port

Syntax Use this command to configure the MGCP user agent port on a BSGX4e.

config mgcp ua port <number> name <name> userid <id> codec1

NOTUSED] codec3

NOTUSED] rfc2833 [yes|no] payload <type> mpt [on|off] fax

[on|auto|off] vad [yes|no] up [yes|no]

Parameters port number Enter the port number 1.

name name Enter the name for the display.

userid id Enter the User ID of the MGCP account.

G729A_20|NOTUSED

Enter the most preferred codec and packet

time. The default is PCMU_20.

codec2

G729A_20|NOTUSED

Enter the most preferred codec and packet

time. The default is PCMA_20.

codec3

G729A_20|NOTUSED

Enter the most preferred codec and packet

time. The default is G729A_20.

codec4

G729A_20|NOTUSED

Enter the most preferred codec and packet

time. The default is notused.

rfc2833 off|on Enable/disable RFC 2833 for DTMF. RFC2833

provides out of band DTMF event reports.

Distortion from compression and

decompression can prevent recognition of pure

DTMF tones. Out-of-band DTMF sends the

information by separate RTP packets. The

default is yes.

payload type If RFC2833 is enabled, the RTP dynamic

payload type can be specified (96-127). The

default is 101

mpt off|on Enable/disable modem pass-through and force

media to G.711 echo cancellation. Specify on

(enabled) if a modem is connected to the

BSGX4e. The default is off.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 183 184

No comments

Avaya BSGx4e CLI User's Guide Page 75