b. Configure incoming call route. The # is used here instead of "n" to avoid
problems with "Main". The minus sign means the number is processed from the
left and so will wait for the whole number.
• Line Group ID: 701
• Incoming Number: -100x
• Destination: #
c. Repeat for Line Group ID 702 etc.
d. Create short codes, for example:
• Short Code: 100x
• Telephone Number:
• Line Group ID: 701
• Feature: Dial
S0 calls dialed without the area code are handled locally without network charges.
Calls with area calls will go via the network.
Example 2: video conference
About this task
In this example, calls are routed to a Polycom Viewstation module connected to a S0 port of
the B5800 Branch Gateway system.
The following settings were used on 4 incoming data channels of a PRI line:
• Line Number: 5
• Channel Allocation: 23 -> 1
• Switch Type: 5ESS
• Line Sub Type: PRI
• Provider: AT&T
• Channels: 1-4
• Incoming Line Group: 95
• Outgoing Line Group: 95
• Direction: Bothway
• Bearer: Data
• Service: Accunet (this is a important)
• Admin: In Service
Additional system procedures
224 Implementing B5800 Branch Gateway for a CS 1000 Configuration October 2012
Comments to this Manuals