Avaya B5800 User Manual Page 66

  • Download
  • Add to my manuals
  • Print
  • Page
    / 324
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 65
Warning:
• Correct anti-static protection steps should be taken before handling circuit boards.
• Cards must never be added or removed from the control unit while it has power
connected.
Tools required
• 5mm Flat-blade screwdriver
• Anti-static wrist strap and ground point
Installing a base card
Procedure
1. Check that there is no power to the control unit.
2. Using a flat-bladed screwdriver, remove the cover from the slot on the front of the
control unit that will be used for each card being installed.
This cover is no longer required but should be retained until installation has been
completed.
3. Allowing the card to rest against the bottom of the slot, begin sliding it into the control
unit.
4. When half inserted, check that the card rails have engaged with the slot edges by
trying to gently rotate it. If the card rotates, remove it and begin inserting it again.
The card should slide in freely until almost fully inserted.
Hardware and software installation
66 Implementing B5800 Branch Gateway for a CS 1000 Configuration October 2012
Page view 65
1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 323 324

Comments to this Manuals

No comments