Avaya B5800 User Manual Page 65

  • Download
  • Add to my manuals
  • Print
  • Page
    / 324
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 64
Installing a legacy carrier card
Procedure
1. Check that correct cards have been supplied.
2. Ensure that you are wearing an anti-static wrist strap connected to a suitable ground
point.
3. On the carrier card identify the position of the jumper block and stand-off pillar holes
for the IP400 card.
The peg holes are labeled as VCM or TRUNK.
4. If fitting an IP400 trunk card, identify which of the plastic snap-off panels on the front
of the carrier card need to be removed to allow the trunk cable connections.
5. Carefully remove those panels.
6. Fit the stand-off pillars to the legacy carrier card.
7. Using minimal force and checking that the pins are correctly located, push the IP400
card onto its jumper and the stand-off pillars.
Base card insertion
Having prepared each base card by adding the trunk daughter cards or legacy carrier cards,
the base card can be inserted into the control unit.
Base and trunk card installation
Implementing B5800 Branch Gateway for a CS 1000 Configuration October 2012 65
Page view 64
1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 323 324

Comments to this Manuals

No comments