48 Configure the provisioning server
•
STUN_SERVER_IP1[ip_address] NAT traversal using STUN protocol
requires a STUN server in the public internet. Two STUN server IPs
can be provisioned.
— ip_address - is the IP address of STUN server 1.
•
STUN_SERVER IP2[ip_address] NAT traversal using STUN protocol
requires a STUN server in the public internet. Two STUN servers IPs
can be provisioned.
— ip_address - is the IP address of STUN server 2.
•
STUN_SERVER_PORT1[port_number] is the port number used
corresponding to STUN_SERVER_IP1. The default port number is
3478.
— port_number - is the port number.
• STUN_SERVER_PORT2[port_number] is the port number used
corresponding to STUN_SERVER_IP2. The default port number is
3478.
— port_number - is the port number.
VQMon configuration commands
•
VQMON_PUBLISH [YES | NO] is the command that is used to enable
or disable the publish message containing the voice quality monitoring
metrics sent to the Proactive Voice Quality Monitoring (PVQMoN)
collecting server.
— YES - enables VQMoN.
— NO - disables VQMoN. NO is the default.
•
VQMON_PUBLISH_IP [xxx.xxx.xxx.xxx] is used to set the IP address
of the PVQMoN server that collects voice quality monitoring metrics
from the publish message.
•
LISTENING_R_ENABLE [YES | NO] is used to enable or disable the
detection of the Listening R Value to measure voice quality based
on burst packet loss, transmission delay, and burst loss frequency.
LISTENING-R_ENABLE is represented using a scale from 0 (lowest
quality) to 100 (highest quality).
— YES - enables the sending of the Listening R Value.
— NO - disables the sending of the Listening R Value.
•
LISTENING_R_WARN [xx] is a threshold to report a warning on the
Listening R Value. The default value is vocoder-dependent and is 80.
SIP Fir mware Release 1.1 for IP Phone 1140E Administration
NN43113-300 02.05 Standard
27 May 2008
Copyright © 2008, Nortel Networks
.
Comments to this Manuals