117377-A Rev. A 3-1
Chapter 3
Enabling X.25 Service
This chapter describes how to enable X.25 service. It assumes you have read
Configuring and Managing Routers with Site Manager and
1. Opened a configuration file
2. Specified router hardware if this is a local mode configuration file
When you enable X.25 service, you must configure a subset of X.25 parameters.
The Configuration Manager supplies default values for the remaining parameters.
If you want to edit these default values, see Cha
pter 4, “Editing X.25 Parameters.”
Enabling X.25 on an Interface
To enable X.25 service:
1. Select the link or net module connector on which you are enabling X.25.
2. Select the X.25 Protocol.
3. Configure packet-level parameters.
4. Add X.25 service records.
The following sections describe how to perform each of these steps.
Comments to this Manuals