Avaya B5800 User Manual download pdf (Page 18)

7. In the Install confirmation dialog box, select Yes.

8. In the Package Selection dialog box, select OK.

9. In the Configure Network Interface dialog box, select Yes.

Note:

B5800 Branch Gateway supports only a single network interface.

10. In the Network Configuration for eth0 dialog box, select Activate on boot and

Enable IPv4 support.

Note:

IPv6 is not currently supported.

11. In the IPv4 Configuration for eth0 dialog box, select Manual address

configuration.

Note:

It is recommended that you use manual address configuration rather than

DHCP.

12. In the IP Address and Prefix (Netmask) fields, enter the appropriate addresses.

Note:

Do not use a restricted address such as 127.0.0.1.

13. Select OK.

14. In the Miscellaneous Network Settings dialog box, do the following:

a. In the Gateway field, enter the appropriate IP address.

b. In the Primary DNS field, enter the appropriate IP address. This field is

optional.

c. In the Secondary DNS field, enter the appropriate IP address. This field is

optional.

15. Select OK.

If the server PC has multiple network interfaces, the Network Configuration dialog

box is displayed and shows whether or not the network interface(s) has been

configured.

Note:

Only a single network interface is supported.

16. In the Hostname Configuration dialog box, do one of the following:

Note:

Having a hostname makes the server easier to access than using its IP

address.

Software installation

18 Implementing Standalone Voice Mail for the Avaya B5800 Branch Gateway June 2012

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 61 62

No comments

Avaya B5800 User Manual Page 18